Earthquake Precursor Research ©GeoSeismic Labs 2007. Supplement to Volume 7

GeoSeismic Labs Reports: Data Research All forecasts are based upon Quantitative Analysis using Empirical Methods. Any information related to a forecast expressed by GeoSeismic Labs is considered a test of a hypothesis, and experimental in nature. The FAULT WHISPERER ™

GSL's Reports Were Viewed   Times Since May 11, 2005

Near Real-Time Data Display Web Page

MT/ULF Real-Time Data is Captured and Uploaded to the Server Approximately Once Every 3 Hours.

Channel Numbers 1(top) thru 4(bottom) Display Information:

• 1 = Band-Pass Filtered and Amplified ULF Data from the MT Sensor's Output.
  Indicates the level of disturbance within the sub-ionosphere at time of detection.
• 2 = Low-Pass Filtered Seismic Data from a 1 Hz Vertical Geophone(Seismometer).
  Also, indicates when a Nucleation of Stress Event is currently in Progress (AE).
• 3 = 1 to 20 Hz (Active) Tracking Filter Infrasonic Voltage Output.
  Indicates when a strong Upper Level Shear Stress Signal is Active.
• 4 = Magneto-Telluric Data (MT) DC level Varies in Response to
  inferred Viscoelastic Fluid (Stress) Changes at Depth near the location of the lab
  at the Pacific-North American Plate Boundary; San Andreas Fault (Cajon Pass).
  MT Pulsations are induced into the Equatorial Region within the zone of preparation
  as a semi-diurnal sub-ionospheric pulse, which travels via the Equatorial Electrojet
  located at the magnetic dip equator in the South Pacific Region called Polynesia.
  You should look for such disturbances between 05:00 and 06:00 UTC,
  and again between 17:00 and 18:00 UTC each day.

---

My philosophy, quite simply stated is:

The Plate Boundary including the western edge of the ECSZ is the
interface for the transmission of Infrasonic, or AE. Secondary faults
are the handshake lines, which handle the nucleation of the stress. The data lines are the harmonics, which indicate the severity and the approximate lattitude of the location by having a different amplitude and frequency for each of the specific harmonics in the infrasound spectrum. I monitor and record these frequencies, and analyze the results, which allows me to publish a specific forecast of the current regional lithospheric stress level. It's not magic, just good old fashioned hard work while conducting an analysis. I believe these infrasonic signals are the same ones, which enable many pets, wild animals, and humans to sense an increase in the level of stress before an earthquake happens. Also, I utilize the Spring Tides, Lunar Phases and Solar Activity level in my forecasts.

-Frank Condon
Independent Earthquake Precursor Research Consultant

NOTE: A more detailed version is available
as my  Statement Summary.

All Earthquakes

California, Nevada, & Baja Earthquakes

Most Recent Regional Seismic Events

Red Puma

Anza Network

CA Quake Alert

Frank Condon... FAULT WHISPERER ™ This information is provided as a public service by GeoSeismic Labs of California, a State Registered "Not for Profit" Public Benefit Corporation Since 2001. REMEMBER GEOSEISMIC LABS IS FUNDED BY PRIVATE DONATIONS FROM INDIVIDUALS LIKE YOU... SO PLEASE HELP! http://www.geo-seismic-labs.org